Series X STD and MMC - Generation 1 - Chassis Update [15_2021_ECN]

To ensure continuous compliance to IACS E10 and product safety, we have decided to implement a product design update for all products in Series X STD & MMC G1. The new IACS E10 rev 8 requirements involve compliance to higher frequencies, hence this update. The change is not required by all models or variants, but to keep similarity between models and common parts - it is decided to update across the product range as described below.

The change is visible as a cosmetic update in the form of smaller ventilation holes in the chassis. Similar updates will be made to other product ranges as well.

Hatteland Technology AS hereby informs about changes for the following model(s):

CHANGE(S) APPLIES FOR THE FOLLOWING HATTELAND TECHNOLOGY PRODUCT(S):
HD 12T21 STD-xxx-Fxxx
HD 15T21 STD-xxx-Fxxx
HD 17T21 STD-xxx-Fxxx
HD 19T21 STD-xxx-Fxxx
HD 24T21 STD-xxx-Fxxx
HD 26T21 STD-xxx-Fxxx
HD 12T21 MMC-xxx-xxxx
HD 15T21 MMC-xxx-xxxx
HD 17T21 MxC-xxx-xxxx
HD 19T21 MxC-xxx-xxxx
HD 24T21 MxC-xxx-xxxx
HD 26T21 MxC-xxx-xxxx
Note: Customized models are ALSO affected by this Engineering Change Notification.

EFFECTIVE FROM:
Gradual implementation, starting during Q4 2021.

If samples are needed, or a strictly controlled backlog management for current / new model, please
contact your Sales Representative.

CHANGE(S):
Chassis ventilation holes changed to small round.
Mx Black Nylon blank screws added to acc kit, in case bracket are not used.

ADDITIONAL INFORMATION:
We will not change the part numbering for this change.

Review updated Sales Drawing for all affected models below.

For further enquiries regarding this Engineering Change Notification, please contact Support at Hatteland Technology AS.