Hatteland Display hereby informs about changes for the following model(s):
|
|
JH 15T17 xxD-xxx-xxxx | JH 19T14 xxD-xxx-xxxx |
|
|
JH 20T17 xxD-xxx-xxxx | JH 22T11 xxD-xxx-xxxx |
|
|
JH 23T14 xxD-xxx-xxxx |
CHANGE(S) APPLIES FOR THE FOLLOWING HATTELAND DISPLAY® PRODUCT(S):
JH 15T17 xxD-xxx-xxxx
JH 19T14 xxD-xxx-xxxx
JH 20T17 xxD-xxx-xxxx
JH 22T11 xxD-xxx-xxxx (Revised - added to this document 7 December 2016)
JH 23T14 xxD-xxx-xxxx
Note: Customized models are ALSO affected by this Engineering Change Notification.
EFFECTIVE FROM:
Gradual implementation starting from November 28th 2016.
Existing Product Type Numbers remain unchanged. Revised Datasheets and User Manual/Technical Manuals available below.
CHANGE(S):
- LED indicators on keypad, brightness change.
- Orange LED indicators on keypad disabled/removed.
- Keypad rubber material change.
- Implementation of BRI command in SCOM protocol.
For details, see below.
ADDITIONAL INFORMATION:
Brightness change, LED indicators:
Requirements in IEC 62288 Edition 2.0 is max 1cd/m2, and readable in night mode.
- Firmware is updated to comply with this requirement.
Orange LED indicators:
- Before change: Orange LED's on the keypad when buzzer is activated.
- After change: No LED's when buzzer is activated.
Reason for change: to comply with IEC62288 Edition 2.0.
Rubber change, surface treatment:
- Existing surface treatment is End of Life (factory change).
- New paint and process has been identified, tested and approved.
- Improved cosmetic appearance.
SCOM BRI command:
- Added support for BRI, please refer to page 11 in the SCOM Technical Manual (INB100018-3).
For further enquiries regarding this Engineering Change Notification, please contact HelpDesk at Hatteland Display.
Implemented by: ____________________________________________________ Frode Grindheim Vice President Product Management Hatteland Display AS |